Mag Shri Enterprises

We manufacture keeping an impeccable spectrum in our insight for our Portable Abrasive Blasters.

Customers can make use of varied media as an abrasive for different activities and finishes.

Fabricated in accordance with the set industrial guidelines, our range is available in standard and customised specifications.

Machine to be made from 6 mm thick MS plate all sides, hopper below blast chamber and top.
01 Nos Blast wheel 15.50 x 2.50, bi-directional 10.0 HP, 2250 RPM Belt Driven type Wheel.
02 Nos Door will be provided with Swing Table and Drive Arrangement (Cantilever supported by standing fabricated boom).
Manganese steel lining to be provided in the direct blast zone chamber remaining area will be covered with 6 mm thick rubber lining.
All liners inside the direct blast zone chamber to be replaceable (bolted).
10 mm thickness Mn liners to be used.
Double Door Swing Table Shot Blasting Machine (Work Load Capacity 400 kgs.).
01 Nos of Blast Wheel Assy. Fitted on top of cabinet.
The Hopper will be covered with M.S. Perforated Sheet 10 mm Thick.
Soundabrator valve to muffle noise will be provided.
Machine will be supplied with Media Separation System.
All motors to be used of ABB/Bharat Bijli Makes only 415V/3Ph/50Hz .
All Bearings to be used of NBC/SKF/KKK/FK make.
Pneumatics will be provided of Janatics/Rotex/Airmax.
All electrical connections and wiring of the Panels will be properly crimped, routed, cased and will not be left loose.
All shafts, keyways, keys, bearings, fasteners to be metric size only.
Machine will be provided with one point pneumatic supply (Compressed Dry Air in buyer's scope). All pneumatic piping from point of supply to wherever air is required (Sound Abrator valve, shot adding device cylinder) will be AEPL scope. FRL unit to be supplied. Air supply to the dust collector shall be 1 pipe and separate from the machine.
Abrasive Separator and Elevator Assembly
Elevator head section to be made from 5 mm thick MS Sheet
Elevator boot section to be made from 5 mm thick MS Sheet
Elevator intermediate section to be made from 10 SWG sheet metal.
Abrasive separator section to be made from min 10 SWG sheet metal.
Shot hopper below abrasive separator unit to be made out of 10 SWG or reinforced in areas prone to wear by continuously falling shots if not made out of 10 SWG.
Removable tray to be provided in the separator at the point where buckets discharge shots into the separator for periodic cleaning.
Using dome nuts with spike bolt for mounting of buckets on the elevator conveyor.
We will provide 2 copies of operation and maintenance manuals will be required.

Machine will have Horizontal Door on both side of blast cabinet. Door will be constructed from mild steel sheet & on outer periphery of the door special rubber sealing will be provided, so that when door is closed it will completely seal the blast cabinet thus prevent the escape of the re-bouncing media.

Shot-blasting equipment called a tumblast is used to prepare surfaces for coatings of protection.

Castings and forgings can be cleaned with this shot blasting machine.

The Tumblast Shot Blasting Machine offers an aesthetically pleasing finishing for dye-cast alloy steel, zinc, and aluminum.